Upgrade (Auro-3D)
.
Sound mode
Channel output
Front
L/R
Center
Surround
L/R
Surround
Back
L/R
Front
Height
L/R
Top Front
L/R
Top Middle
L/R
Top Rear
L/R
Rear
Height
L/R
Surround
Height
L/R
Top
Surround
Front
Dolby
Atmos
Enabled
L/R
Surround
Dolby
Atmos
Enabled
L/R
Back Dolby
Atmos
Enabled
L/R
Subwoofer
Auro-3D
SDD D Dz7 DDz8 D
Auro-2D Surround
SDDD D
z1
The applicable sound mode includes “Dolby Surround” and sound modes that have “+Dolby Surround” in the sound mode name.
z2
The applicable sound mode includes “DTS Neural:X” and sound modes that have “+Neural:X” in the sound mode name.
z3
A signal for each channel contained in an input signal is output as audio.
z4 Audio is not output when “Speaker Config.” - “Surr. Back” in the menu is set to “1 spkr”. (v
p. 228)
z5 Audio is output from the speakers specified in the “Surround Parameter” – “Speaker Select” settings. (v
p. 181)
z6 Audio is output when “Subwoofer Mode” in the menu is set to “LFE+Main”. (v p. 235)
z7
For the best Auro-3D experience Surround Height speakers are recommended, however you may substitute Rear Height speakers from a Dolby Atmos speaker setup in
place of Surround Height speakers.
z8
This is output if an Auro-3D signal is input and the input signal contains Top Surround.
Contents
Connections Playback Settings Tips Appendix
301
Front panel Display Rear panel Remote Index
To Next Page
Loading...
Need help?
General
Weight and Dimensions
