Denon AVR-X510BT - Precautions During Service; Initializing This Unit

Initializing This Unit
Initialize this unit if you have replaced the microcomputer, one of the parts around the microcomputer, or the digital PCB.
1. Press the power button (
X
) to turn off the power.
2. AVR-S500BT: Hold down buttons "SOUND MODE
1
" and "PRESET +" at the same time and press the power button
to turn on the power.
AVR-X510BT: Hold down buttons "PRESET +" and "TUNE +" at the same time and press the power button to turn on
the power.
3. Releasethebuttonsafterconrmingthatthedisplayashesinintervalsofapproximately1second.
The unit is initialized.
[AVR-S500BT]
[AVR-X510BT]
NOTE: • If the status in step 3 does not occur, start again from step 1.
  •Initializingthedevicerestoressettingsconguredbytheusertothefactorysettings.
Takenoteofyoursettingsbeforehandandrecongurethemafterinitialization.
MASTER VOLUME
SOURCE SELECT
BAND MODE DIMMER STATUS
TUNE
TUNER
PRESET CH
SOUND MODE
SETUP MICPHONES
5V/1A
CBL/SAT
3
1
QUICK SELECT
GAME
ON / OFF
BASS /
TREBLE
TONE CONTROL
2
DVD/Blu-ray
4
Bluetooth
ADJUST
SOUND MODE 1
PRESET +
X
MASTER VOLUME
SOURCE SELECT
SETUP MICPHONES
5V/1A
GAMECBL/SAT
31
DIMMER STAT US
TUNER
PRESET CH
TUNE
DVD/Blu-ray
2
Bluetooth
4
QUICK SELECT
TUNE +
X
PRESET +
PRECAUTIONS DURING SERVICE
11