Denon AVR-X6800H - Page 248

Front Speaker
Set the front speaker A/B to use for every sound mode.
A
(Default):
Front speaker A is used.
B : Front speaker B is used.
A+B : Both front speakers A and B are used.
0
This can be set when “Amp Assign” is set to “9.1ch + Front B”. (v p. 227)
2ch Playback
Select the method for setting the speakers used in the 2-channel direct
and stereo playback modes.
o
Setting
Select the method for setting the speakers used in the 2-channel direct
and stereo playback modes.
Auto
(Default):
The settings in “Speakers” are applied.
(v p. 215)
Manual:
Set the speakers for 2-channel playback.
Make the following settings.
o
Crossover
Set the maximum frequency of the bass signal output from each
channel to the subwoofer.
Full Range:
Select “Full Range” to set the speaker to
play full-range audio.
40 Hz / 60 Hz / 80 Hz /
90 Hz / 100 Hz / 110 Hz /
120 Hz / 150 Hz / 180 Hz /
200 Hz / 250 Hz
(Default: 80 Hz)
Selects the crossover point to send the
low frequency sound to the subwoofer.
Contents Connections Playback Settings Tips Appendix
248
Front panel Display Rear panel Remote Index