Tips
Simple operations in the power off state
0
When a input source select buttons, 1/3 button, FAVORITES CALL button or 5
button is pressed, the operation is performed at the same time as the
unit switches on. (v
p. 28, 38)
0
When the “Network Control” is set to “On”, you can perform playback, or other operations through AirPlay, Denon “Hi-Fi Remote” app. (v p. 79)
Simple operations for iPod/USB
0
When connected to the USB port, the Input Source automatically changes and playback begins. (v p. 41, 44)
I only want to recharge my iPod
0
Connect the iPod to this unit when the unit power is on. Then turn the unit power off, and the iPod will continue to charge until fully charged.
(v
p. 43)
Specifying the iPod track with the alarm function
0
Connect the iPod to this unit by USB and then press the MODE button to register your favorite tracks in the favorites using Browse iPod
mode. (v p. 38) Then set a track registered in the favorites as the alarm. (v p. 74)
0
When using alarm playback on an iPod touch or iPhone, set the iPod touch or iPhone to “Sleep” mode. If the power is switched off using the power off
operation, alarm playback cannot be used.
Specifying the desired track with the alarm function
0
After registering the desired track in NAS, etc., register the track in the favorites and then specify the track in the alarm settings. (v p. 74)
Change to summer time
0
Select “General” - “Clock” in the setup menu and configure the settings.
(v
p. 75)
Contents Connections Playback
Settings
Tips Appendix
87
Front/Top
panel
Rear panel
Remote control unit
Index
To Next Page
Loading...
Need help?
General
