Denon CEOL Piccolo DRA-N5

13
Setting the general [General]
n Update on web screen
Firmware can be updated using the “Web control function”
(vpage38).
“Web control function” (vpage 38) settings must be
completed in advance on a PC belonging to the same network.
For information on obtaining update files, please contact our
customer service center.
1
Click r from step 5 for the “Web control function”
(vpage 38).
The PC will display the following screen.
Wait for approximately 1 minute.
You can also gain access by entering the IP address shown by
the unit into a web browser.
Please wait...
FIRMWARE
Now,go to the new IP displayed in the body.
If do not move the page within 1 minute,please refer to IP.
GThe web displayH
GThe unit’s screen displayH
2
When the following screen is displayed by the PC,
click the “Choose File” (q) button, select the update
le, and click the “Upload” (w) button.
Firmware
Upload new firmware
Upload
Choose File
q
w
3
When the following screen is displayed, click the
“OK” (e) button.
Updating will begin.
Firmware
Warning:
Once started,the upload process cannot be interrupted or adorted,
in order to ensure the integrity of the Digital Media Player.
Are you sure you want to proceed?
OK
e
NOTE
Do not operate the unit while updating is in progress.
4
When the following screen is displayed, updating is
complete.
Firmware
New Firmware:
xxx.fw
Firmware upload status: 100% completed.
The upload process finished successfully.
Please close this.
Button names may vary depending on the OS language used on your
computer.
n Notification
Update
Displays a notification message on this unit’s menu screen when the
latest firmware is released with “Update”.
Connect to broadband Internet (vpage 7) when using this
function.
1
Press SETUP.
Turns on the Menu settings mode
and the Menu appears on the display
(vpage9 “Menu map”).
2
Use ui and ENTER to select
“General” – “Firmware” –
“Notication” – “Update”, then
press ENTER or p.
“Update Notification” menu appears.
3
Use ui to select “On”, then
press ENTER or p.
On Display update message.
Off Do not display update message.
•When you press ENTER during display of the notification message,
the “Check for Update” is displayed. (Refer to page 12 for more
information on “Update”.)
•Press o to erase the notification message.
Preparations
Operations
Information
Preparations