.
Playing digital input
1
Prepare for playback.
Check the connection, then turn on this units. (“Connecting a digital
device” (v p. 23))
2
Press OPTICAL IN to switch the input source to
“Optical In 1” or “Optical In 2”.
3
Play the component connected to this unit.
0
If the sampling frequency cannot be detected, “Signal Unlock” will
be displayed.
0
“Unsupported” is displayed when audio signals that are not
supported by this unit are input.
Contents Connections Playback Settings Tips Appendix
67
Front/Top
panel
Rear panel
Remote control
unit
Index
To Next Page
Loading...
