Clock Mode
You can display the time when in standby by setting the Clock Mode.
On: Time is displayed in standby.
Off
(Default):
Time is not displayed in standby.
0
When in standby and “Clock Mode” is set to “On”, the unit consumes more
standby power than when in normal standby.
IR Control
Assign operations on this unit to the remote control of your TV. This
enables you to operate this unit with the remote control of your TV.
1
Use ui to select the operation on this unit to be
performed with the remote control of your TV and
press ENTER.
Volume Up / Volume Down / Mute / Power Toggle / Power On /
Power Off / Quick Select 1 / Quick Select 2 / Quick Select 3 /
Input HDMI Out (ARC) / Input Optical In / Input AUX In
0
The operations indicated by a check mark are already assigned to the TV
remote control. To assign an operation to a different button, press ENTER
while the operation is indicated by a check mark to remove the check mark,
then configure the setting again.
2
Follow the instructions in the display to configure the
setting.
The set operation on this unit is indicated by a check mark after the
setting is complete.
Contents
Connections Playback Settings Tips Appendix
93
Front/Top
panel
Rear panel
Remote control
unit
Index
To Next Page
Loading...
