H/P Amplifier Gain
Set the gain of the headphone amplifier. Set this according to the
impedance of the connected headphones. It is recommended that this is
set on the “Low” side if the headphones have low impedance and on the
“High” side if they have high impedance.
High:
Set the gain of the headphone amplifier to
“High”. Set this if the volume is too low at
the factory default setting.
Mid
(Default):
Set the gain of the headphone amplifier to
“Mid”.
Low:
Set the gain of the headphone amplifier to
“Low”. Set this if the volume is too high at
the factory default setting.
NOTE
0
The headphone volume varies depending on the H/P Amplifier Gain setting.
Decrease the volume or mute the audio first if changing this setting while listening
to audio.
Speaker Optimization
Performs audio processing optimized to our SC-N10 speakers (not
included) and outputs an audio signal.
On
(Default):
Performs audio processing optimized to our
SC-N10 speakers (not included).
Off: The response is flat.
Contents Connections Playback Settings Tips Appendix
92
Front/Top
panel
Rear panel
Remote control
unit
Index
To Next Page
Loading...
