.
Playing digital input
1
Prepare for playback.
Check the connection, then turn on this units. “Connecting a digital
device” (v p. 19)
2
Press OPTICAL IN to switch the input source to
“OPTICAL”.
3
Play the component connected to this unit.
NOTE
0
Do not input non-PCM signals, such as Dolby Digital and DTS. This causes noise
and could damage the speakers.
0
“UNLOCK” is displayed when audio signals that are not supported by this unit are
input, or the sampling frequency cannot be detected.
o
Specifications of supported audio formats
See “DIGITAL IN” (v p. 61).
Contents
Connections Playback Settings Tips Appendix
38
Front panel Rear panel
Remote control
unit
Index
To Next Page
Loading...
