Denon DCD-315 - Page 13

ae a a ee OCO-315 fas
TEST METHOD FOR HEAT RUN MODE
1. Actuate
While hold pushing > , 6 and 7 buttons simultaneously, turn the unit power on. The remote control sensor indicator will light
to show that the unit is shifted in Heat Run mode.
Press the button to cancel Heat Run mode after loading disc.
2. Operation
1) Heat Run test
During the Heat Run mode to start in Play mode, it makes the unit replays from the first track after opens the loader when
finishing with playing last track. After that, this operation is over again. When disc has over 21 tracks, makes the unit to search
the last track and set operation times.
2) Chucking test
Press|PAUSE | button 2 times in the Heat Run mode, it makes the unit opens the loader, turns the servo ON, reads out TOC,
operates first track search and does over again.
3) Sound out test
During the Heat Run mode, press +10 button to start in Play mode. If it generates over + 8 frame sound out, stop the operate
and display the error message.
3. Error Message
When the system error occurs in the Heat Run mode, display the error message with TRACK and operated times with TIME.
1) E1 error Focus Servo does not activate.
2) E2 error GFS does not drive.
3) E3 eroor No GFS emit.
4) E4 error TOC is unreadable.
5) E5 error Does not turn the Loader switch ON.
6) E6 error Does not turn the Pick-up inner circle switch OFF.
7) E7 error Does not turn the Pick-up inner circle switch ON.
8) E8 error Sound out.
13