Denon DCD-F109 - Page 24

24
2.3. Pickup movement
(1) In the stop mode, pickup moves in REV (inwards) or FWD (outwards) direction when
8
or
9
button pressed.
(2) When
8
button pressed, move to stop operation after detection that inner switch has turned on.
(3) Pickup movement stops when button released. (Pickup moves while button is pressed.)
• Continuous display of previous time.
2.4. Stop
(1) When
2
button is pressed, play operation and servo stop.
(2) After stopping, conduct reading of auto adjust values.
•
13
ashing
2.5. All servo on
(1) When
2
and
5
button is pressed, all servos turn on, auto adjustment is performed and switch to playback operation.
(Playback sound output)
•
13
ashing
(@@ : T.No, XX:XX : Time)
※
Press the
2
button, then press the
5
button.
NOTE :
When the
2
button is pressed for over 1 second while the laser turns on and the laser current is measured.
2.6. Laser current is display
(1) When the
2
button is pressed for over 1 second while the this unit is in the stop mode (CD TEST MODE display), the
laser turns on and the laser current is measured.
(2) The laser drive current undergoes A/D conversion for calculation. Decimal values are discarded.
(3) The rst current value is measured 3 seconds after the laser turns on.
(4) The current value is updated every 3 seconds.
(5) Press the
2
button, CD test mode display reappears.
(6) Stored data is not cleared, even when the this unit is reset
•
13
ashing.
(XX : Stored data : EEPROM Stored value, YY : Current value)
q
Overwriting the stored data
(1) When the
1
/
3
button is pressed for over 5 seconds while the laser current is displayed, the current value is
stored in the EEPROM (overwriting the stored data).
(2) Once rewriting is completed, the display in 2.6 reappears.
(3) Rewriting is performed upon shipment from the factory and when the mechanism is replaced.
@@ Tr XX:XX
S
/C: XXXmA/YYYmA
L
ASER CURRENT
S
TORED
L
ASER CURRENT