Denon DN-D9000 - Basic Operation and Scratching; Playback, Pause, and Cue Operations; Pitch Adjustment and Pitch Bend; Scratch Mode Operations

11
DN-D9000
128 33
97 64
132
96 65
TOP VIEW
SEMICONDUCTORS


 IC’s
Note: Indication before IC Numbers denotes P.W.B. name.
FG : CD-ROM P.W.B. Unit
DS : DSP P.W.B. Unit
PO : Power P.W.B. Unit
RC : Remote P.W.B. Unit
MN102H730F (DS: IC501)
MN102H730F Terminal Function
Function
I/O
Pin
No.
Pin Name
Symbol
1 CS0_ CS0_ O — Pu — — Ext. memory chip select 0 (Flash ROM CS)
2 CS1_ CS1_ O — Pu — — Ext. memory chip select 1 (Flash ROM for memo)
3 D00 DQ0 I/O — — — — Ext. memory data in/output 0, DSP interface 0
4 D01 DQ1 I/O — — — — Ext. memory data in/output 1, DSP interface 1
5 D02 DQ2 I/O — — — — Ext. memory data in/output 2, DSP interface 2
6 D03 DQ3 I/O — — — — Ext. memory data in/output 3, DSP interface 3
7 VDD VDD — — — — — Power (+3.3V)
8 VSS VSS — — — — — GND
9 D04 DQ4 I/O — — — — Ext. memory data in/output 4, DSP interface 4
10 D05 DQ5 I/O — — — — Ext. memory data in/output 5, DSP interface 5
11 D06 DQ6 I/O — — — — Ext. memory data in/output 6, DSP interface 6
12 D07 DQ7 I/O — — — — Ext. memory data in/output 7, DSP interface 7
13 D08,P10 KEYIN2 I — Pu H H OPEN/CLOSE2 key input
14 D09,P11 KEYIN1 I — Pu H H OPEN/CLOSE1 key input
15 D10,P12 FPLAY1 I — Pu H H CD1 fader start PLAY input
16 PD0,DMAACK1_ FCUE1 I — Pu H H CD1 fader start CUE input
17 PD1,DMAREQ1_ FPLAY2 I — Pu H H CD2 fader start PLAY input
18 D11,P13 FCUE2 I — Pu H H CD2 fader start CUE input
19 D12,P14 JOGA2 I — (Pu) H H JOGA pulse input for CD2 scratch (Direction detect)
20 D13,P15 JOGB2 I — (Pu) H H JOGB pulse input for CD2 scratch (Direction detect)
21 D14,P16 JOGA1 I — Pu H H JOGA pulse input for CD1 scratch (Direction detect)
22 D15,P17 JOGB1 I — Pu H H JOGB pulse input for CD1 scratch (Direction detect)
23 WORD WORD I — — Data bus width select (H: 8bit), VDD fixed
24 VDD VDD — — — — — Power (+3.3V)
25 MODE MODE I — — L L Processor mode, GND fixed
DET Ext Ini Res