Denon DN-F400

3
1. GENERAL INFORMATION
i
DISPLAY button
• The elapsed time, remaining time, or display off is displayed in order by pressing this
button. (See page 9)
o
LOCK button
• Hold the button pressed for more than 1 second to lock out key operation on the front
panel.
• Hold the button pressed for more than 1 second additionally to release lock-out of key
operation on the front panel.
!0
4button
• Press this button once to skip to the beginning of the current track or to the previous
track.
• Hold the button pressed to start playback as FR. (See page 11)
!1
¢ button
• Press this button once to skip to the next track.
• Hold the button pressed to start playback as FF. (See page 11)
DN-F400 Rear panel
zxc v b n m,.
z
ANALOG OUTPUT jacks
• These are analog unbalanced outputs using RCA type pin jacks.
x
ANALOG OUTPUT jacks
• These are analog balanced outputs using PHOENIX balanced output jacks.
c
Output LEVEL control
• Use this to control the audio output level.
• This controls signal output from the analog balanced and unbalanced jacks
simultaneously.
v
PARALLEL connector
(See page 19)
b
MODE switch
• Use this switch to set various playback modes. (See page 11)
n
RS-232C serial connector
• Use this connector to control with a host device externally.
• Connect the RC-F400S using the RS-232C straight cable supplied with the RC-F400S.
(See pages 6, and 15 to 18.)
m
POWER ON/OFF switch
• Slide the knob to turn the power on or off.
,
DC power inlet
• Connect the included AC power adaptor.
.
Mounting hole for the DC power cord holder
• Attach the holder to prevent disconnection of the cord from the connector.
(See page 7)