Denon DNP-800NE - Accessories; Safety and Documentation

Make sure to initialize this unit after replacing the microcomputer or any peripheral equipment, or the
PCB.
1. Press the power operation button to turn off the power, and remove the AC plug from the socket.
2. Insert the AC plug while pressing buttons "SOURCE" and "BACK" together, and wait for more than 3
seconds.
3. Release buttons "SOURCE" and "BACK" when the power indicator turns green.
4. All lights on the display illuminate for 2 seconds.
5. All lights on the display turn off for 2 seconds.
6. The Power indicators illuminate in orange for 4 seconds during this time.
7. "Factory Reset" is shown on the display for 5 seconds.
The settings for the Installer Setup is also initialized.
Network function settings are not initialized.
NOTE： • If the unit fails to enter the service mode in step 7, repeat the procedure from step 1.
• Initializing the device restores the customized settings to the factory settings. Write down
your settings in advance and recongure the settings after initialization.
Use network initialization mode to initialize the network related settings.
1. Press the power operation button to turn off the power, and remove the AC plug from the socket.
2. Insert the AC plug while pressing button "POWER", and wait for more than 3 seconds.
3. Release button "POWER" when the power indicator turns green.
4. Once "Special model" is displayed, press "CURSOR
f
", select "Initialize" then press the "Enter" button.
5. All lights on the display turn off for 5 seconds.
6. "Initialized" is shown on the display for 5 seconds.
・All settings, including network function settings, are initialized.
7. "Initialized" is displayed and the power turns off 90 seconds later.
(The network device is started and initialized during this time.)
BACK SOURCE
Initializing this Unit
POST-SERVICE PRECAUTIONS
Before Servicing
This Unit
Electrical Mechanical Repair Information Updating
7