Denon DR-F7 - Input;Output Jacks and Tape Controls

e
12. Output level (OUTPUT LEVEL)
The playback output level or the record monitoring output
level are adjusted independently from the level meter
indications. The headphone output level is also adjusted
by this knob.
13. Input level (INPUT LEVEL)
The input levels of the left and right channels are adjusted
independently in accordance with the signal level to be
recorded. The front knob is for the left (L) channel and the
rear knob is for the right (R) channel.
14. MPX filter switch (MPX FILTER)
15. Microphone jacks (MIC)
Plug in the microphone plugs for microphone recordings.
Use microphones with an output level higher than —67dB
and a 6 mm diameter plug.
16. Headphone jack (PHONES)
Use for enjoying music through the headphones or for
” monitoring the recording. Use a headphone set with an
impedance of 8 ohms to 2 Kohms.
17. FTS preset button (FTS PRESET)
This button allows the switchover between the preset
standard bias/recording sensitivity and those calculated by
the FTS using a microprocessor.
18. FTS start button (FTS START)
This button starts the operation of the microprocessor
controlled FTS system. While the bias and the sensitivity
are being automatically adjusted by the FTS, the green
lamp on the left will flash. Once the adjustments are com-
pleted, the lamp will stay lit.
19. Tape control buttons
PAUSE/MUTE Button
When this button is pressed during playback, the tape trans-
port will stop and the green lamp in the PLAY button will
be
turned
off.
An
orange
lamp
in
the
PAUSE/MUTE
button
will light up, indicating the PAUSE condition. While this
button is pressed during recording, the tape will run with
no signals being recorded. When the button is released, the
tape transport will stop. The orange lamp and red lamp in
the REC button will light up, indicating the standby con-
dition, When starting the recording again, press the PLAY
button ( P ).
RECORD Button
Load the cassette tape and press this button. This places the
unit in standby for recording (pause). The red and orange
lamps will light up. Press the PLAY button ( > ) to start
recording.
*If the erase prevention tab of the loaded cassette tape is
broken off, this button does not function.
PLAY Button »
When pressed during STOP, FAST FORWARD or REWIND
mode, playback begins and the green lamp will light up.
When pressed during standby in the recording (pause)
mode, the recording will start.
STOP Button M
When pressed during any operational mode, the operation
is stopped.
REWIND Button 4 4
When pressed, the tape is rewound onto the left spool
rapidly.
FAST FORWARD Button لم󰾯
When pressed, the tape is wound onto the right spool
rapidly.