Denon DRM-650S - Timer Recording and Playback; Timer Recording Procedure; Timer Playback Procedure

2) MEMORY STOP Operation
(1) During recording or playback, the Memory Stop feature can be
used to locate a particular point on the tape. Press the COUNT-
ER MEMORY button at the desired point.
(2) The “MEMO" indicator lights.
(3) When the Rewind ( <q ) button is pressed, the tape is rapidly
rewound until the counter indication of ” @088 ” is reached.
@ The Memory Stop feature will rewind the tape to within —5
counts (from “8880 "to" -@005 “). After this, several seconds
are required for corrective operations.
TIMER RECORDING / PLAYBACK
3) Display Back-up
The functions DOLBY NR, MPX FILTER, AUTO TUNING and the
countercontentare protected by 24-hour memory back-up. After 24
hours DOLBY NR and MPX FILTER are set to “OFF” and the counter
content is resetto”” 0200 ".
Caution:
If the memory stop operation is performed after repeated fast-foward-
ing or rewinding, the tape may not stop at the proper position.
Timer recording/ playback can be made using any audio timer available on the market.
DRM-650S Amplifier
Tuner
e@ Timer recording procedure
1. Make sure the connections are correct, especially the power supply
connections.
2. Turn “on” the power switch of each appliance.
3. Tune the desired station on the tuner.
4. Load the tape for recording. (Make sure the erase prevention tab is
not broken off; if it is, cover the hole with plastic tape).
5. Set the Dolby NR button to the appropriate position.
6. Make sure the monitor switch to the SOURCE position.
7. Adjust the recording input level.
8. Set the starting position of the tape.
9. Set the timer switch (TIMER) to the “REC” side.
TIMER
REC OFF PLAY
10. Set the audio timer to the desired time. The audio timer will turn the
power supply on at the desired time.
* With the above procedures, timer controlled recording can be
made. When the preset time comes, the power is supplied and the
FM broadcast can be recorded.
Speaker System
@ Timer playback procedure
. Make sure the connections are correct, especially the power supply
connections.
. Turn “on” the power switch of each appliance.
. Load the pre-recorded tape to be played back.
. Set the Dolby NR switches to the appropriate positions.
Set the monitor switch of the Amplifier to the TAPE position.
. Press the PLAY ( p> ) button and playback the tape; adjust the play-
back level.
Press the stop ( MH) button.
7. Set the timer switch (TIMER) to the “PLAY” side.
TIMER
REC OFF PLAY
=
OanRWwn
—p_
8. Set the audio timer to the desired time. The audio timer will turn the
power supply on at the desired time.
* Withthe above procedures, timer playback can be accomplished.
When the preset time comes, the power is supplied and playback will
start.
Note:
e@ Please read the operating instructions for the timer before use.
e Ifthe timer recording or playback is not desired, be sure to switch the
timer switch (TIMER) to “OFF”.
e@ When using timers that allow several “on/off” operations, timer
start functioning can continue an unlimited number of times until the
tape in the machine is finished.
11