27
32. Platter: This capacitive, touch-sensitive platter
controls the audio playhead when the wheel is
touched and moved.
33. Jog Display: This display shows information relevant
to the performance, including the current playhead
position, active deck, and track BPM. See Jog
Display below for more information.
34. Deck: Selects which deck in the software is controlled
by that hardware deck. The left deck can control Deck
1 or 3; the right deck can control Deck 2 or 4.
Press and hold Shift and then press the Deck 3 or
Deck 4 buttons to switch between four-deck and two-
deck operation.
35. Track Skip Back: Press this button to skip to the
previous track.
Press this button in the middle of a paused track to
return to the beginning of the track.
Press and hold Shift and this button to search
backward through the track.
36. Track Skip Forward: Press this button to skip to the next track.
Press this button in the middle of a paused track to go to the next track.
Press and hold Shift and then press one of these buttons to search forward through the track.
37. Beat Jump: Press either of these buttons to skip backward or forward through the track.
Press and hold Shift and press one of these buttons to increase or decrease the beat jump size.
38. Cue: During playback, press this button to return the track to the initial cue point and stop playback. To move
the initial cue point, make sure the track is paused, move the platter to place the audio playhead at the desired
location, and then press this button.
If the deck is paused, press and hold this button to temporarily play the track from the initial cue point. Release
the button to return the track to the initial cue point and pause it. To continue playback without returning to the
initial cue point, press and hold this button and then press and hold the Play button, and then release both
buttons.
During playback, press and hold Shift and then press this button to set the initial cue point at the current
playhead position.
39. Play/Pause: This button pauses or resumes playback.
Press and hold Shift and then press this button to “stutter-play” the track from the initial cue point.
40. Vinyl: Press this button to activate/deactivate a “vinyl mode” for the platter. When activated, you can use the
platter to “scratch” the track as you would with a vinyl record. When deactivated (or if you are touching only the
side of the platter), move the platter to temporarily adjust the track’s speed.
41. Sync: Press this button to activate sync. When Key Lock is activated, the track’s key will remain the same even
if you adjust its speed.
Press and hold Shift and press this button to turn off key lock.
42. Key Sync: When a track is playing back, press and hold this button to activate key sync to that track.
Press and hold Shift and press this button to reset to the track’s original key.
43. Pitch Fader: Move this fader to adjust the speed (pitch) of the track.
44. Pitch Bend –/+: Press and hold one of these buttons to momentarily reduce or increase (respectively) the speed
of the track.
Press and hold Shift and then press one of these buttons to set the range of the pitch fader.
38
32
33
34
36
35
37
39
40
41 42
43
44
To Next Page
Loading...
