Denon engine dj SC LIVE 4 - Advanced Deck Performance Features; Slip Mode and Beat Grid Editing; Censor and Reverse Playback; Performance Pad Modes

28
45. Slip: Press this button to enable or disable Slip Mode.
In Slip Mode, you can jump to cue points, trigger loop
rolls, or use the platters, while the track’s timeline
continues. In other words, when you stop the action,
the track will resume normal playback from where it
would have been if you had never done anything (i.e.,
as if the track had been playing forward the whole
time).
Press and hold Shift and then press this button to
enable beat grid editing.
Press and hold Shift and then press this button while
beat grid editing is enabled to reset the beat grid.
Press and hold Shift and then press and hold this
button while beat grid editing is disabled to manually
adjust cue/loop point locations left or right using the
touchscreen controls.
46. Censor / Reverse: Press this button to activate/
deactivate the Censor feature: the playback of the
track will be reversed, but when you release the
button, normal playback will resume from where it
would have been if you had never engaged the
Censor feature (i.e., as if the track had been playing
forward the whole time).
Press and hold Shift and then press this button to reverse the playback of the track normally.
47. Shift: Press and hold this button to access secondary functions of other controls.
48. Performance Pads: These pads have different functions on each deck depending on the current pad mode. See
Pad Modes for more information.
49. Hot Cue: Press this button to enter Hot Cue Mode.
50. Loop: Press this button once to enter Manual Loop Mode, and press it again to enter Auto Loop mode.
51. Roll: Press this button to enter Roll Mode.
52. Slicer: Press this button once to enter Slicer Mode, and press it again to enter Slicer Loop Mode.
53. Parameter /: Use these buttons for various functions in each Pad Mode. See Pad Modes for more information.
54. Auto Loop/Loop Move: Turn this knob to set the size of an automatic loop. The value will be shown in the
touchscreen and platter display.
Press this knob to activate or deactivate an automatic loop at the current location of the track.
Press and hold
Shift and turn this knob to shift the active loop to the left or right.
55. Loop In/Loop Out: Press either of these buttons to create a Loop In or Loop Out point at the current location.
Their placement will be affected by the Quantize and Smart Loops settings. See Looping & Beat-Jumping for
more information.
Press and hold Shift and press either of these buttons to manually adjust the loop in and out points.
Jog Display
1. Playhead Position: Indicates the current position of the playhead.
2. Selected Deck: Shows the active deck.
3. BPM: Shows the BPM of the track loaded to the active deck.
4. Track Time: Shows the elapsed or remaining time for the track. Tracks
shorter than one hour will be shown as MM:SS:ss. Tracks longer than one
hour will be shown as HH:MM with an “HR” label next to the time.
2
1
4
3
45
46
47
50
51
52 53
54