Denon HEOS 1 - Closing the Splashguard Properly; Turning Off the Go Pack Battery

CLOSE SPLASHGUARD
1
Remove the power connector from the speaker.
2
Press in the Splashguard so that it is firmly and evenly
attached.
.
Properly attaching the splashguard will make your HEOS 1 speaker
waterproof to the IPX4 standard. DO NOT submerge the speaker in water!
TURNING OFF THE BATTERY
To turn off the battery, press and hold the button on the back of the battery
for 2 seconds. The LEDs will flash quickly then turn off, indicating that the
battery is off.
Turning off the battery will conserve battery power while you are not
playing music and HEOS 1 is not plugged in to AC power.
To turn the battery back on, press and hold the button again for 2 seconds.
.
NOTE
While the battery is disconnected from HEOS 1, it is always off.
Contents Setup Use Troubleshooting Status LED Appendix
46