Adjusting the High Pass Filter
Set the High Pass Filter to limit the low frequency signal being sent to your
speakers.
1
Select “High Pass Filter”.
2
Select the frequency cutoff point:
40 Hz / 60 Hz / 80 Hz / 90 Hz / 100 Hz / 110 Hz / 120 Hz / 150
Hz / 200 Hz / 250 Hz
If you enable the IP control, “High Pass Filter” will be disappeared and forced to
change.
Adjusting the Status Light Brightness
1
Select “Status Light”.
2
Adjust the brightness up or down or set the slider to
the OFF position to completely disable the status light.
Using a Subwoofer
1
Select “Subwoofer”.
2
Enable the Sub Out (L) setting.
If you enable the IP control, “Subwoofer” will be disappeared and forced to change.
Adjusting the Low Pass Filter
When Subwoofer is set to on, you can limit the high frequency signal being
sent to your subwoofer.
1
Select “Subwoofer”.
2
Select “Low Pass Filter”.
3
Set the frequency cutoff point.
80 Hz / 90 Hz / 100 Hz / 110 Hz / 120 Hz / 150 Hz / 200 Hz / 250
Hz
Contents Setup Use Troubleshooting Status LED Appendix
40
To Next Page
