Denon HEOS HS2 - Page 5

HEOS Amp QUICK START GUIDE
4
Français Español Deutsch Nederlands Italiano Svenska Dansk Norsk
Pусский
Polski
English
STEP 3: CONNECT
OPTIONAL
If you are connecting the HEOS Amp to a wired network, connect the included Ethernet cable between the
HEOS Amp and your router. Do not connect the Ethernet cable if you are connecting your HEOS Amp to a
wireless network.
Connect the power cordConnect the speakers
ECT
1
2
A. Remove 10 mm of sheathing from the
tip of the speaker cable, then either
twist the bare wire tightly.
B. Turn the speaker terminal
counterclockwise to loosen it.
C. Insert the bare wire into the speaker
terminal.
D. Turn the speaker terminal clockwise to
tighten it.
HEOS Amp HS2 E2_QSG_151125.indd 4 2015/12/23 12:41:26
PrintingColor:FullColor