Need help?Do you have a question about the Denon PMA-2000 IV - Amplifier and is the answer not in the manual?
General| Signal to Noise Ratio (Line) | 108 dB |
|---|---|
| Input Sensitivity (MM) | 2.5 mV |
| Signal to Noise Ratio (MC) | 74 dB |
| Speaker Load Impedance | 4 - 16 ohms |
| Frequency Response | 5Hz - 100kHz |
| Output | Rec Out |
| Dimensions | 434 x |
| Input Sensitivity (Line) | 135mV / 47k ohms |
Check leakage current or line to chassis resistance. Unit is defective if values exceed limits.
Details rated output power, THD, input sensitivity, and amplification factor.
Details PHONO EQUALIZER specs like rated output, input sensitivity, RIAA deviation.
Covers SN ratio, tone control range, and other general performance metrics.
Lists power supply, outlets, consumption, dimensions, and net mass.
Specifications for the remote control unit, including system, power, dimensions, and mass.
Instructions for removing the top cover by unscrewing specific parts.
Steps for disassembling the front panel, including knob and nut removal.
Procedure to remove the bottom plate by unscrewing multiple parts.
Steps to detach the rear panel by removing specific screws.
Instructions for removing the heat sink assembly by unscrewing parts.
Instructions on positioning the unit and setting controls before adjustment.
Step-by-step guide for adjusting idling current using a voltmeter and specific resistors.
Detailed pinout and function description for the TMP87CC46N-4C08 microcomputer.
Pinout and typical application diagram for the LB1639 IC.
Pinout and typical application diagram for the BA4558/NJM2082D IC.
Block diagram and typical application of the GP1U27X sensor.
List of transistors with front view and typical circuit examples.
List of additional transistors with front views.
List of diodes and LEDs with part numbers and types.
Details for Thyristor SF0R3G42 with front view.
Details for Thermistor PTH9M04BD222TS2F333.
Component layout diagram for the Power Amp P.W.B. unit.
Component layout diagram for the Input P.W.B. unit.
Component layout diagram for the Flat Amp P.W.B. unit.
Explains resistor coding and types.
Explains capacitor coding, types, and markings.
Comprehensive list of parts for the Power Amp Unit.
List of resistors for the Power Amp Unit.
List of capacitors for the Power Amp Unit.
List of miscellaneous parts for the Power Amp Unit.
Comprehensive list of parts for the Input Unit.
List of semiconductors for the Input Unit.
List of resistors for the Input Unit.
List of capacitors for the Input Unit.
List of miscellaneous parts for the Input Unit.
Comprehensive list of parts for the Flat Amp Unit.
List of semiconductors for the Flat Amp Unit.
List of resistors for the Flat Amp Unit.
List of screws used in the assembly.
Diagram showing how the unit is packed with accessories.
List of packing materials and included accessories.
Schematic for the Equalizer/Input unit.
Schematic for the Protector unit.
Schematic for the Function Switch unit.
Schematic for the Power Supply unit.
Schematic for the Flat Amplifier unit.
Schematic for the Volume unit (2000/4R).
Schematic for the Volume unit (2000/4).
Schematic for the Control unit.
Schematic for the Left Power Amplifier unit.
Schematic for the Right Power Amplifier unit.
Schematic for the Pre Out unit.
Schematic for the Source Direct Switch unit.
Schematic for the LED unit.
Schematic for the AC Outlet unit.
Schematic for the Power Switch unit.
To Next Page
