G
Select the “PMA-1700NE” format.
0
It is normally recommended to set the format to “2 ch 32-bit Integer
384.0 kHz”.
H
Quit Audio MIDI Setup.
o
Playback
Install the desired player software on your computer beforehand.
Use the rear panel USB-DAC port to connect this unit to a computer.
(v p. 23)
1
Press the input source select button (USB-DAC) to
switch the input source to “USB-DAC”.
Start playback on the computer’s player software.
0
If the sampling frequency cannot be detected, “Unlocked” will be
displayed.
0
“Unsupported” is displayed when audio signals that are not
supported by this unit are input.
Contents Connections Playback Settings Tips Appendix
39
Front panel Rear panel
Remote control
unit
Index
To Next Page
Loading...
