To Next PageTo Next PageWhy is my Denon PMA-1500RII Amplifier power LED on but there is no sound?
If the power LED on your Denon Amplifier is lit but you're not getting any sound, here are a few things to check: * Ensure the speaker cords are securely connected. * Verify that the INPUT SELECTOR is set to the correct position. * Make sure the VOLUME control is turned up to an audible level.
Why is my Denon Amplifier remote not working?
If your Denon Amplifier isn't responding to the remote control, try these steps: 1. Replace the batteries with new ones. 2. Move closer to the amplifier. 3. Remove any obstacles between the remote and the amplifier. 4. Ensure you're pressing the correct button. 5. Verify the batteries are inserted with the correct polarity.
What to do if my Denon PMA-1500RII Amplifier sound is only coming from one side?
If sound is only coming from one side of your Denon Amplifier, consider the following: * Check that the speaker cords are securely connected. * Ensure the input cords are properly connected. * Adjust the BALANCE control to center the sound.
Why is there a booming sound when playing records on my Denon PMA-1500RII Amplifier?
If you're experiencing a booming sound when playing records on your Denon Amplifier, try the following: * Ensure the turntable’s ground wire is securely connected. * Verify that the input cords are properly connected to the PHONO terminals. * Relocate the turntable away from potential interference sources like TVs or VCRs.
Why is there howling when playing records loudly on my Denon PMA-1500RII Amplifier?
If you hear howling when the volume is turned up while playing records on your Denon Amplifier, it could be due to: * The turntable and speaker systems being too close together; move them as far apart as possible. * A soft floor that vibrates easily; use cushions to absorb vibrations from the floor to the speakers, or use audio insulators if the turntable doesn't have them.
Why are the stereo positions inverted on my Denon Amplifier?
If the positions of instruments sound inverted for stereo sources on your Denon Amplifier, the left and right speakers or input cords may be inverted. Check the left/right connections.
Why is the volume different between tuner and records on my Denon PMA-1500RII?
If you notice a volume difference between the tuner and records on your Denon Amplifier, it's likely due to different output levels. Adjust the tuner output to match the turntable’s output, if your tuner has an output control.
General| Frequency Response | 5 Hz - 100 kHz |
|---|---|
| Dimensions | 434 x 151 x 370 mm |
| Output | Speaker terminals |
| Speaker load impedance | 4 - 16 ohms |
| Damping Factor | 100 (8 ohms, 1 kHz) |
Essential precautions to prevent fire, shock, and damage to the unit.
Adjusts overall volume and channel balance.
Details speaker connection, impedance, and bi-wiring.
Solutions for no sound, distorted sound, or channel issues.
Troubleshooting booming, howling, and distorted vinyl playback.
Resolving problems with the remote control unit.
Details on output power, sensitivity, and distortion.
SN ratio, frequency response, power supply, consumption.
Physical size, weight, and remote control details.
