14
PORTUGUÊSSVENSKANEDERLSNDSITALIANODEUTSCH FRANCAIS ESPAÑOLENGLISH
■ Check the following before assuming there is a problem with the set.
1. Are all connections proper ?
2. Is the set being operated as described in the operating instructions ?
3. Are the speakers and input components being operated properly ?
If the set does not seem to be operating properly, check the points listed below. If these points do not apply, the set may
be damaged. Turn off the power immediately and contact your store of purchase.
5 TROUBLESHOOTING
Symptom Cause Measures Page
Common problems arising when listening to the CD,MD,records, tapes, and FM broadcasts, etc.
Power LED does not light and no
sound is produced when POWER
switch is turned on.
• Power supply cord is not con-
nected.
• Check that the cord is plugged in. 10
Power LED lights but no sound is
produced.
• Speaker cords not properly con-
nected.
• lNPUT SELECTOR not set to
proper position.
• VOLUME control turned down.
• Connect securely.
• Set to the proper position.
• Set to an appropriate level.
9, 10
8, 11
8, 11
Sound is not produced from one
side only.
• Speaker cords not properly con-
nected.
• Input cords not properly connected.
• Left/right balance improperly
adjusted.
• Connect securely.
• Connect securely.
• Adjust the BALANCE control.
9, 10
10
8, 11
Volume level is different when lis-
tening to tuner and records.
• Tuner and record outputs different. • Adjust the tuner output to the turn-
table’s output (if the tuner is
equipped with an output control).
-
Positions of instruments inverted for
stereo sources.
• Left and right speakers or input
cords inverted.
• Check the left/right connections. 9, 10
Problems occurring when playing records.
Booming sound produced when
playing records.
• Turntable’s ground wire not con-
nected.
• Input cords not properly connected
to PHONO terminals.
• Influence from a TV or VCR near
the turntable.
• Connect securely.
• Connect securely.
• Change the position of installation.
10
10
-
Howling produced when volume is
turned up while playing records.
• Turntable and speaker systems are
too close.
• Floor is soft and vibrates easily.
• Move speaker systems as far away
as possible.
• Use cushions to absorb the vibra-
tions transmitted from the floor to
the speakers. If the turntable does
not include insulators, use audio
insulators, available in stores.
-
-
Sound is distorted.
• Stylus pressure is too light.
• Dirt on tip of stylus.
• Defective cartridge.
• Apply proper pressure.
• Check the tip of the stylus.
• Replace the cartridge.
-
-
-
Remote control unit.
This unit does not operate properly
when remote control unit is used.
• Batteries dead.
• Remote control unit too far from
this unit.
• Obstacle between this unit and
remote control unit.
• Different button is being pressed.
• and ends of battery inserted
in reverse.
• Replace with new batteries.
• Move closer.
• Remove obstacle.
• Press the proper button.
• Insert batteries properly.
12
12
12
13
12
To Next Page
Loading...
