Denon PMA-800NE - Connecting and playing back from a digital device (Coaxial;Optical); Audio signals that can be played back

Connecting and playing back from a
digital device (Coaxial/Optical)
1
Connect digital device to this unit. (v p. 22)
2
Press the input source select button (COAXIAL,
OPTICAL 1, OPTICAL 2 or OPTICAL 3) to switch the
input source to “COAXIAL”, “OPTICAL 1”, “OPTICAL 2”
or “OPTICAL 3”.
The indicator of the selected input source lights.
3
Start playback of the digital device connected to this
unit.
DIGITAL AUDIO IN indicator lights.
0
The DIGITAL AUDIO IN indicator blinks when audio signals that are not
supported by this unit are input.
0
If the sampling frequency cannot be detected, the DIGITAL AUDIO IN
indicator turns off.
o
Audio signals that can be played back
See “D/A converter” (v p. 40).
NOTE
0
Do not input non-PCM signals, such as Dolby Digital, DTS and AAC. This causes
noise and could damage the speakers.
0
If the sampling frequency switches, the sound may cut for 1 - 2 seconds.
Contents
Connections Playback Settings Tips Appendix
29
Front panel Rear panel
Remote control
unit
Index