Denon PMA-A110 User Guide

The installation of the driver software is not necessary in the following cases.
When you do not play back the music from a PC using USB-DAC of this unit.
When using a macOS.
The driver software cannot be installed correctly if your PC is connected to the unit by a USB cable. If the unit and
your computer are connected by a USB cable and the computer is switched on before installation, disconnect the
USB and restart the computer.
Windows OS
System requirements: Windows 8.1 or Windows 10
1. Download the dedicated driver from the “Download” section of the PMA-A110 page of the Denon website
(https://www.denon.com/) onto your PC.
2. Unzip the downloaded file, and double-click the EXE file.
3. Install the driver.
Select the language to use for the installation.
Click “OK”.
The wizard menu is displayed. Follow the instructions on the screen.
When the wizard is completed, click “Yes”.
NOTE:
Please see the FAQ at www.denon.com if you experience any issues getting audio to play from your computer
through the PMA-A110. You may also want to check the support pages for audio player application.
Connect to PC or Mac

Denon PMA-A110 Specifications

General

Input Sensitivity MM	2.5 mV / 47 kOhm
Treble Control	±8 dB at 10 kHz
Bass Control	±8 dB at 100 Hz
Standby Consumption	0.2 W
Dimensions	434 x 182 x 450 mm
Total Harmonic Distortion	0.007%
Frequency Response	5 Hz - 100 kHz
Input Sensitivity MC	200 µV / 100 ohm
Power Output (8 Ohm)	80 W (20 Hz - 20 kHz, THD 0.07%)