.
OPTICAL IN1
OPTICAL IN2
ANALOG IN
Listening to DIGITAL IN
1
Prepare for playback.
Check the connection “Connecting a digital device” (v p. 20), then
turn on this units.
2
Press OPTICAL IN1 or OPTICAL IN2 to switch the input
source to “OPTICAL IN 1” or “OPTICAL IN 2”.
3
Play the component connected to this unit.
NOTE
0
Do not input non-PCM signals, such as Dolby Digital and DTS. This causes noise
and could damage the speakers.
0
“SIGNAL UNLOCK” is displayed when audio signals that are not supported by this
unit are input, or the sampling frequency cannot be detected.
o
Specifications of supported audio formats
See “DIGITAL IN” (v p. 69).
Contents
Connections Playback Settings Tips Appendix
45
Front panel Display Rear panel Remote Index
To Next Page
Loading...
Need help?
General
