19
ENGLISH
14
PRESET
1. Preset mode
q The preset mode is available when
!7
PRESET button is pushed for more than 1 sec while DN-S1000 is
in Cue, pause or no disc mode.
w Turn the @3 PARAMETERS knob to select the preset item.
e After selecting an item, push the @3 PARAMETERS knob to select the preset data.
r To change other Preset items, repeat these steps.
t Push the
!7
PRESET, i CUE or
y
PLAY / PAUSE (
13) button to exit from the Preset mode.
2. Preset items and data
The “*” mark next to the data indicates the default value.
(1) Auto Cue : Auto Cue level search on/off. (A Cue ON* / A Cue OFF)
(2) Next Track : Cross_OFF / Cross1sec / Cross2sec* / Cross3sec
Select the time for fading out the currently playing track when playback of a new track is started with
the next track function.
(3) S-Stroke (SCRATCH STROKE) : Short*/Long
Allows you to select a comfortable stroke distance for scratching “Long” is set for wide pattern strokes
and “Short” is set for small pattern strokes.
(4) Scratch : Delay_OFF* / Delay -1- / Delay -2- / Delay -3-
Select the time after which the normal play or pause mode is set after scratch play stops.
(5) Jump Time : Jump10sec* / Jump20sec / Jump30sec / Jump1min
Select the skip time of Quick Jump.
(6) P. Range (PITCH RANGE) : 4% Range / 10% Range* / 16% Range / 24% Range
Select the playing pitch range when the power is turned on.
(7) EOM Time : Track end message start time.
(EOM OFF / EOM 10 sec* / EOM 15 sec / EOM 20 sec / EOM 30sec / EOM 60 sec / EOM 90 sec)
(8) Total Time : Total ON / Total OFF*
Total time display on / off.
(9) Fader Mode (FADER START MODE) : Play / Cue* / Play / Pause
Select 2-line type (Cue and Play) or 1 line type (Play and Pause).
(10) Power Play (POWER ON PLAY) : P. Play ON / P. Play OFF*
Playback starts when the power is turned on if a disc is loaded.
(11) Pitch : Pitch ON* / Key AdjON (KEY ADJUST ON) / Pitch OFF
Select the pitch mode when the power is turned on.
(12) Play Mode (SINGLE / CONTINUOUS / SINGLE PLAY LOCK) : Single / Cont. / Play Lock*
Select the play mode when the power is turned on.
(13) Time Mode (ELAPSED / REMAIN) : Elapsed* / Remain
Select the time mode when the power is turned on.
(14) Memo Clear (MEMO ALL CLEAR) :
Clear all MEMO data in the non-volatile memory.
q To clear all MEMO data, push the PARAMETERS knob.
• “Clear OK?” flashes on the character display.
w Push the PARAMETERS knob again and select “OK” to execute clearing all MEMO data.
• “Memo Clear” is displayed on the character display while clearing.
e Once clearing is completed, “Complete!” is displayed.
(15) Version No. : The DN-S1000’s software version is displayed. (SYSTEM / DSP)
(16) Preset Int.(PRESET INITIALIZE) : Set all the preset data back to the factory defaults.
q To clear the PRESET data, push the PARAMETERS knob.
“Initial OK?” flashes on the character display.
w Push the PARAMETERS knob again and select “OK” to start clear the preset data.
“Preset Int” is displayed on the character display while data clearing.
e Once clearing is completed, “Complete!” is displayed.
To Next Page
Loading...
Need help?
General
