2 Basic Operations
- 9 -
1. Finish communications with the vehicle by PC application software or LCD software.
2. Turn the mode switch of this product OFF.
3. Turn the vehicle starter switch (ignition switch) OFF.
4. Disconnect the USB cable from this product and the PC.
5. Disconnect the datalink cable from the vehicle side diagnosis connector.
6. Disconnect the datalink cable from this product.
2-2 Ending
CAUTION
Do not turn the mode switch of this product OFF or disconnect the datalink cable from this
product during the active test. The diagnosed actuators could be stopped still in the drive
status. Make sure to execute the ending procedure after finishing the active test.
CAUTION
When disconnecting the datalink cable from the vehicle side diagnosis connector, go after turn the
vehicle starter switch (ignition switch) OFF.
Perform the disconnection of step 5 and step 6 according to the order.
To Next Page
Loading...
