Why won't my Dentsply Sirona X-Smart IQ Dental equipment handpiece switch on?
If the Dentsply Sirona Dental equipment handpiece won't switch on, and all LEDs are off, connect the motor handpiece to the charger. If the LEDs are lit but the handpiece doesn't respond when the button is pressed, perform a reset; the motor handpiece will automatically switch to ready mode. If the multifunction button is faulty, contact your service center.
What to do if Dentsply Sirona X-Smart IQ Dental equipment motor won't stop?
If the Dentsply Sirona Dental equipment motor cannot be stopped during preparation, briefly press the multifunction button once to stop the motor. Start and stop the motor again. If the error persists, contact your service center.
Why Dentsply Sirona X-Smart IQ contra-angle cannot be calibrated?
If the Dentsply Sirona Dental equipment contra-angle cannot be calibrated, it may be due to increased resistance in the contra-angle interrupting the calibration procedure. Recalibrate the motor handpiece to rule out a motor fault. Clean and lubricate the contra-angle. Then, start the calibration procedure again.
Why is my Dentsply Sirona Dental equipment motor handpiece getting hot?
If the Dentsply Sirona Dental equipment motor handpiece is getting hot due to overheating, allow the device to cool down before restarting it.
General| Type | Endodontic motor |
|---|---|
| Connectivity | Bluetooth |
| Integrated Apex Locator | Yes |
| Battery | Lithium-ion |
| Cordless Operation | Yes |
| Charging Time | Approximately 2 hours |
| Programs | Customizable programs |
| Autoclave Compatibility | Handpiece is autoclavable |
| Motor Type | Brushless DC Motor |
| Motor Rotation | Reciprocating and continuous |
To Next Page
