Why won't my Dentsply Sirona X-Smart IQ Dental equipment handpiece switch on?
If the Dentsply Sirona Dental equipment handpiece won't switch on, and all LEDs are off, connect the motor handpiece to the charger. If the LEDs are lit but the handpiece doesn't respond when the button is pressed, perform a reset; the motor handpiece will automatically switch to ready mode. If the multifunction button is faulty, contact your service center.
What to do if Dentsply Sirona X-Smart IQ Dental equipment motor won't stop?
If the Dentsply Sirona Dental equipment motor cannot be stopped during preparation, briefly press the multifunction button once to stop the motor. Start and stop the motor again. If the error persists, contact your service center.
Why Dentsply Sirona X-Smart IQ contra-angle cannot be calibrated?
If the Dentsply Sirona Dental equipment contra-angle cannot be calibrated, it may be due to increased resistance in the contra-angle interrupting the calibration procedure. Recalibrate the motor handpiece to rule out a motor fault. Clean and lubricate the contra-angle. Then, start the calibration procedure again.
Why is my Dentsply Sirona Dental equipment motor handpiece getting hot?
If the Dentsply Sirona Dental equipment motor handpiece is getting hot due to overheating, allow the device to cool down before restarting it.
General| Type | Endodontic motor |
|---|---|
| Connectivity | Bluetooth |
| Integrated Apex Locator | Yes |
| Battery | Lithium-ion |
| Cordless Operation | Yes |
| Charging Time | Approximately 2 hours |
| Programs | Customizable programs |
| Autoclave Compatibility | Handpiece is autoclavable |
| Motor Type | Brushless DC Motor |
| Motor Rotation | Reciprocating and continuous |
Provides guidance on initial configuration and setup for the device.
Instructions for enabling Bluetooth to connect the motor handpiece to the iPad.
Guidance on downloading and updating the DENTSPLY ENDO IQ™ application from the App Store.
Instructions for assembling the iPad and motor handpiece with protective case.
Instructions for correctly inserting and removing files from the motor handpiece chuck.
How to use the motor handpiece without the DENTSPLY ENDO IQ™ application.
Details pre-cleaning, thermal disinfection, and sterilization methods for the contra-angle.
To Next Page
