7
jack of an audio device and plug the other end into the Aux -in jack located on back of
the main unit .
2. Press the
button on the main unit or press & hold the key on remote
control to turn on the unit.
3. Press MODE Button until the power indicator turns to Green to enter
the AUX-IN mode.
4. Start the playback of the audio device connected.
5. Press “Vol +” / “Vol – ” key on remote control or press and hold the“>”/ “<”button
on the main unit to raise/lower the volume level. When finished, press and hold the
button on the main unit or press & hold the key on remote control to turn off
the main unit. Remember to turn off your audio device, too.
TROUBLESHOOTING GUIDE
Should you experience difficulties in the use of this player, please refer to the
following chart.
Fault Cause Solution
Unit cannot be
operated.
Unit crashes and
“hangs”
Disconnect from the mains for around 5
seconds. Then switch the unit on again.
Speaker is not paired
to the audio source.
Check whether a connection exists. If
necessary, pair the speaker again to the
audio source.
Increase the volume on the speaker
No audio signal
via the Bluetooth
connection
Volume too low
Increase the volume on the the audio
source.
Pairing does not
work
Check whether the audio source
supports the A2DP protocol
Audio source is
switched off
Switch on the audio source
Bluetooth is switched
off at the audio
source.
Switch on the Bluetooth function in the
audio source.
Speaker cannot
be connected
Bluetooth version is
not supported.
Use a different playback unit.
To Next Page
Loading...
