Denver CR-421 - Setting Alarm Times

the TIME/PRESET to stop blink and start setting.
 The time can only be set when the radio is turned off. Press the ON / OFF / NAP
button (2) to turn radio on or off.
 When the clock display is blinking, you cannot power on radio by the ON / OFF /
NAP utto .
1. Press ad hold dow TIME / PRESET utto  for approiatel  seods
until the display flashes.
2. Press HOUR / TUNING – utto  repeatedly to change the hour setting.
3. Press MIN / TUNING + utto  repeatedly to change the minute setting.
4. Press TIME / PRESET utto  to ofir at the tie ad the displa will stop
flashing.
SETTING THE ALARM TIME
This clock radio has dual alarms that can be set and used independently. The
procedure to set both alarms are the same. Both alarms can either sound the buzzer
or wake up to radio.
Note: The alar tie a ol e set whe the radio is tured off. Press the ON /
OFF / NAP utto  to tur radio o or off.
1. For setting alarm time 1 with buzzer, press ALARM1 / VOL – button (4) and
indicator (E) will flash. For setting alarm time  with radio, press ALARM1 /
VOL – utto 4) twice and indicator (F) will flash.
2. When the digits are flashing, press HOUR / TUNING – utto  repeatedly to
hage the hour settig. Press MIN / TUNING + utto  repeatedly to change
the minute setting.
3. Press ALARM1 / VOL – button (4) to confirm.
4. To cancel alarm, press ALARM1 / VOL – button (4) three times when the current
time is showing. The alarm indicators will be off.
5. When the alarm sounds, press any button to turn off alarm or press SNOOZE /
DIM / SLEEP utto  to enter snooze mode. or will blink during
snooze mode. Alarm will sound again after 5 minutes. Alarm buzzer does not cut
the radio sound. If alarm waken up by radio, volume control for radio is not
available.
6. Follow the sae istrutios for alar tie  with ALARM / VOL + utto 8).