Denver CR-421 - Radio Operation; General Radio Functions; FM Station Memory; Sleep and Nap Modes

Note:
 You must make the time and alarm time adjustments while the display is flashing.
The display will stop flashing after approximately 10 seconds if adjustments are
not made.
 If two alarms are set together, for example alarm1 set to buzzer alarm and alarm2
set to radio alarm, when buzzer is activated by alarm1 and radio is activated by
alarm2, the previous alarm does not stop automatically and has both buzzer and
radio sound together.
RADIO OPERATION
General Operations
1. Press the ON/OFF/NAP utto  to tur radio o ad off.
2. For aual tuig, press HOUR / TUNING – utto  or MIN / TUNING
+ utto  for increments of 0.1mHz.
3. For automatic tuning, press and hold dow HOUR / TUNING – utto  or
MIN / TUNING + utto  for approximately 3 seconds. Release the button
and the radio will start to scan for the next available station.
4. Press ALARM1 / VOL – utto  or ALARM / VOL +utto  to adjust
volume level. The display changes to show the volume level indication (00 to 14)
during the volume adjustments, then changes back to the radio station frequency
and then the current time.
5. Press HOUR / TUNING – utto  or MIN / TUNING + utto  to show the
radio station frequency.
Pre-set Station Memory
1. The radio can store up to 20 FM stations.
2. To store a station in memory, tune to the desired radio station. Press and hold
dow TIME/PRESET utto  for approiatel  seods ad P o the
displa will flash. Press P+ utto  or P- utto  to the desired station
eor P to P. Press TIME/PRESET utto  oe to ofir.
3. Repeat the above steps for up to 20 stations.
4. To reall the statio, press P+ utto  or P- utto  util desired statio
is reached.
Sleep mode
1. Whe the radio is o, press SNOOZE / SLEEP / DIM utto  to enter sleep
ode. OFF will e displaed. Press SNOOZE / SLEEP / DIM utto 