14
days in off mode, before it is fully discharged. If only partially charged, this period is
lower.
Please make sure the battery does not get above 50° Celsius, or below minus 10° Celsius
for a longer period. (e.g., don’t leave the electric scooter in a hot car in summer, do not
put battery into fire etc.) Low temperature (e.g., subzero temperature) can damage the
battery cells.
Keep the Electric scooter away from open flame or other sources of heat to prevent the
battery from getting too hot. Also make sure not to leave the electric scooter at freezing
temperatures. Both heat and excessive cold can cause the battery to discharge.
Only use original charger or an official replacement, as different batteries may require
specific charger, and if using other chargers, this could cause damage to the product.
Do not overcharge and discharge the battery.
Please make sure to charge the battery before it is completely out of power, to avoid
damaging the battery cells. (Damaged battery caused by wrong handling is not covered
by the warranty)
It is forbidden to disassemble battery package. This is only to be handled by official
service repair centers and professionals.
Bearings, Screws, Brakes and Wheels
Your electric scooter is made up of moving parts, which in time, will be susceptible to
wear and tear.
Bearings and screws:
The electric scooter has sealed and dustproof bearings so that no lubrication is required.
Check the bearings for wear at regular intervals to avoid unsafe riding. Do not jump on
and off and do not apply excessive force otherwise to avoid damage to the bearings. This
is not a sports electric scooter.
Make sure that all screws are properly tightened to avoid unsafe situations. We
recommend tightening average value of 20N/m.
Please check the screws regularly and tighten if they seem loose.
Brakes:
Check the brake for wear at regular intervals to avoid unsafe riding. Do not apply
excessive force to avoid damage to the brake.
To Next Page
Loading...
