EasyManua.ls Logo

Denver SEL-90100F - Page 27

Denver SEL-90100F
29 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
27
Regarding Battery charging SEL-90100F
Important – Please read!
Dear customer. We hope you get a lot of joy out of your new Electric scooter.
The battery built in the Electric scooter is not fully charged from production line and
when left unused the battery can slowly discharge by itself.
This can lead to slow charge if the battery is fully discharged, but this is done to avoid
damage to the battery.
If you experience that you cannot turn on your E-scooter, and it doesn’t seem to charge
(the charger lights up green instantly), then please do the following.
1. Leave the charger in for 7-8 hours. This will make sure the battery will be fully charged
again (it can take 3-4 hours before it starts normal charging).
2. If this does not solve your problem, please ride the Electric scooter manually without
turning it on. Use your legs to give speed, for around 100 m, and then connect the
charger. The engine in the front wheel will this way help to activate the charging
function and it will charge normally. (fully charge takes 7 hours if using this way)
Please enter: www.denver.eu to obtain the electronic version of the manual.