www.desatech.com
113170-01E 3
18. Never move, handle, refuel or service a hot,
operating or plugged-in heater.
19.
Never attach duct work to front or rear of heater.
20. Never attach heater to external fuel tank.
21. Heaters used in the vicinity of tarpaulins,
canvas or similar enclosure materials shall be
located a safe distance from such materials.
The recommended minimum safe distance is
304.8 cm (10 feet). It is further recommended
that these enclosure materials be of a fire
retardant nature. These enclosure materials
shall be securely fastened to prevent them
from igniting or from upsetting the heater due
to wind action.
22. Unplug heater when not in use.
23. Never block air inlet (rear) or air outlet (front)
of heater.
24. Warning to New York City Residents
For Use Only At Construction Sites in ac-
cordance with applicable NYC codes under
NYCFD certificate of approval #4803, #4899,
#4908, #4909 or #4934.
UNPACKING
1. Remove all packing items applied to heater
for shipment.
2. Remove all items from carton.
3. Check items for any shipping damage. If
heater is damaged, promptly inform dealer
where you bought heater.
SAFETY INFORMATION
Continued
FUELS
WARNING: Use only kero-
sene, #1/#2 diesel/fuel oil, JET
A or JP-8 fuels to avoid risk
of fire or explosion. Never
use gasoline, oil drained from
crankcases, naphtha, paint
thinners, alcohol or other highly
flammable fuels.
Use only kerosene, #1/#2 diesel/fuel oil, JET A
or JP-8 fuels. Heavier fuels such as No. 2 fuel
oil or No. 2 diesel fuel may also be used but will
result in:
• noticeable odor
• additional fuel filter maintenance
• the need for nontoxic, anti-icer additives in very
cold weather
Do not use fuels heavier than No. 2 grade or
heavy oils such as oil drained from crankcases.
These heavy oils will not ignite properly and will
contaminate the heater.
IMPORTANT: Use a KEROSENE ONLY (blue)
or DIESEL ONLY (yellow) storage container.
Be sure storage container is clean. Foreign matter
such as rust, dirt or water will cause the ignition
control assembly to shut down heater. Foreign
matter may also require heater's fuel system to be
frequently cleaned.
Lower
Shell
Hot Air
Outlet
Control Cover
Fuel Cap/
Gauge
Upper Shell
Ignition Control
Assembly (On
Inside of Control
Cover)
Fan
Guard
Fuel Tank
Thermostat
Knob
ON/OFF
Switch
Shroud
Rear Panel
Handle
Extension
Cord Wrap
Figure 1 - 125T, 170T and 200T Models
PRODUCT IDENTIFICATION
To Next Page
Loading...
Need help?
General
