To Next PageTo Next Page
Need help?Do you have a question about the Desmi S80-70-175N/A11-09 and is the answer not in the manual?
General| Pump Model | S80-70-175N/A11-09 |
|---|---|
| Material | Cast Iron |
| Impeller Material | Bronze |
| Connection | Flanged |
| Inlet Diameter | 80 mm |
| Outlet Diameter | 70 mm |
| Pump Type | Centrifugal |
| Motor | Electric |
| Speed | 2900 rpm |
| Impeller Diameter | 175 mm |
Guidelines for mounting the pump on a solid base plate, ensuring shaft alignment and avoiding distortion.
Electrical wiring procedures to be performed by authorized skilled workmen according to regulations.
Steps to access the pump impeller by removing the U-pipe, shaft seal cover, and bearing housing.
Procedure for removing the impeller, star wheel, and priming plate, noting care for O-ring.
Instructions for removing the shaft seal by disassembling the bearing housing and shaft seal cover.
Detailed steps for installing the shaft seal, including cleaning, lubrication, and tool use.
Checks and steps required before starting the pump, including shaft rotation and casing filling.
