How to troubleshoot current level issues in Det-Tronics Security Sensors?
To address current level issues with Det-Tronics Security Sensors, you can try the following: * Check the system wiring. * Cycle the power. * Clean the windows. * Remove any IR source or aim the detector away from it.
How to fix continuity issue in wiring of Det-Tronics Security Sensors?
To resolve continuity issues in the wiring of Det-Tronics Security Sensors, turn off the input power to the detector and check all wiring for continuity. Remember to disconnect wiring at the detector before checking system wiring for continuity.
Why is the Det-Tronics Security Sensors detector's sensitivity reduced?
If your Det-Tronics Security Sensors detector's sensitivity is reduced, inspect the viewing windows for contamination, such as thick deposits of ice, dirt, or oil, and clean them as necessary.
What to do if Det-Tronics Security Sensors detect high levels of background IR radiation?
To resolve high levels of background IR radiation affecting Det-Tronics Security Sensors, cover the detector with the factory-supplied cover or aluminum foil. If the fault condition clears within six minutes or less, readjust the view of the detector away from the IR source or relocate the detector.
General| Type | Flame Detector |
|---|---|
| Field of View | 90 degrees |
| Hazardous Area Approvals | FM, CSA, ATEX, IECEx |
| Response Time | Typically 3-5 seconds |
| Operating Temperature | -40°C to +75°C (-40°F to +167°F) |
| Humidity | 0 to 95% non-condensing |
| Power Supply | 18-30 VDC |
| Output Signal | 4-20 mA |
| Communication Protocol | HART |
| Enclosure | Stainless Steel |
| Enclosure Rating | IP66 |
To Next Page
