What to do if Det-Tronics LS2000 Security Sensors show a calibration fault?
A calibration fault in Det-Tronics Security Sensors occurs if the calibration process times out. To resolve this, perform a successful calibration to reset the fault.
How to fix low 24 volts on Det-Tronics LS2000?
If your Det-Tronics Security Sensors are showing a low 24 volts error, it means that the 24 VDC operating voltage is out of the acceptable range. Ensure the wiring to the detector is correct and that the power source is outputting the correct voltage. After correcting the issue, the power supply faults should clear automatically. If the problem continues, it is recommended to consult the factory.
What to do if Det-Tronics Security Sensors have negative signal output?
A negative signal output on your Det-Tronics Security Sensors likely means the device was zero calibrated with background gas present. If this occurs, purge the system with clean air and repeat the zero calibration. Also, make sure the heaters are on and the windows are clear of fog.
How to resolve signal saturation in Det-Tronics Security Sensors?
If your Det-Tronics Security Sensors are experiencing signal saturation, add an aperture to the transmitter module or adjust the lamp voltage as needed.
What to do for other faults on Det-Tronics Security Sensors?
Consult the factory.
Emphasizes compliance with NEC and local ordinances for wiring procedures.
Stresses proper installation and use within specified conditions for hazardous area approval.
Warns against user attempts to service internal components; emphasizes professional repair.
Explains how the LS2000 uses infrared absorption to detect hydrocarbon gases.
Specifies voltage range and power draw of the LS2000 modules.
Outlines factory span calibration and field zero calibration methods.
Advice on selecting suitable locations for installation in hazardous industrial areas.
Emphasizes accurate module alignment and structural integrity of the installation.
Guidance on selecting an adequate power supply for the LS2000 system.
Step-by-step guide for module replacement, listing required tools and torque specifications.
Lists CSA approval details, including hazardous location classifications and temperature ratings.
Explains the necessity of HART communication for monitoring and modifying factory settings.
General| Brand | Det-Tronics |
|---|---|
| Model | LS2000 |
| Category | Security Sensors |
| Language | English |
To Next Page
