Detectalia V75 - Operating the Detector; Turning the Unit On and Off; Manual and Automatic Counting Modes

12
V75
Press the power switch to turn on/off the unit.
Note: When turn on , it will start self-check and all the function words on the LCD are lit up. If there is some problem with
the sensors, then it will show the error code in the display. (details please refer to the point 7: Error code and resolution).
Press AUTO to switch the counting mode.
AUTO: when put the banknotes on the hopper, the machine will start counting automatically.
MNL: when put the banknotes on the hopper, the user should press START to start counting the banknotes.
Notes: In the “AUTO” counting, if the notes are very soft or dirty, then it will lead to the start sensor not work.
Press ADD to turn on/off the ADD function, When the display show “ADD”, it means the ADD function is on; otherwise, the
ADD function is off. The ADD function can work with Batch function.
Press “ BATCH” to turn on/off the batch function, if the user press this key again, then the user can choose the batch num-
ber among “100, 50, 20, 10, off”, or the user can press“+1/10” to set a batch number, the batch range is “0-999.
When the banknote feeding clearance is too loose, the machine will come up with the problem of “double note” and
inaccurate counting number, etc. Then the user can rotate the adjusting screw to the anti-clockwise direction little by little
until the counting is smooth. Please noted that do not rotate it too much in case it will break the notes.
When the banknote feeding clearance is too tight, then the machine will have unsmooth counting, and the notes will be
deformed and damaged. The user should rotate the adjusting screw to the clockwise direction until the problem solved.
Notes: the adjusting screw has been set to a good position before shipping from the factory, so the user is no need to do
the adjustment when they receive the machine. Only when after a long time usage, it may need to do some adjustment.
6.1 Turn on/off
6.2 MNL/AUTO
count setting
6.3 ADD function
6 .4 Batch function
6.5 Banknote feeding
clearance adjustment
6. Operation