Deutz TCD 2013 2V - Page 378

© 02/2010 OBJ_DOKU-21808-001.fm
1/6
6
Engine mounting
TCD 2013 2V W 46-00-01
Mounting engine on assembly block and demounting
Standard tools:
– Lifting gear
– Suspension ropes
Special tools:
– Assembly block incl. adap
-
ter plates 6066
– Clamping bracket 6066/158
– W 01-01-01
– W 47-01-01
Danger!
When using hoists (workshop crane) the
safety regulations for handling hoists must
be observed.
It is not permitted to stay under moving
loads.
Mounting engine on assembly block
● Removing the crankcase breather.
 W 01-01-01
● Hang engine on suitable workshop crane.
● Remove mounting feet.
 W 47-01-01
X
X
X
© 43943-0
● Mount clamping bracket 6066/158-3 (1) on crank
-
case.
● Tighten screw (2).
 90 Nm
● Mount clamping bracket 6066/158-1 (3) on holder.
● Tighten screws (4) and lock nuts.
 90 Nm
2
1
3
4
X
X
X
© 43945-0