3. Mount and reassemble the thermostat:
▪
Fasten the thermostat to a flush-mounting box
or a surface-mounting box by driving the screws
through the holes in each side of the thermostat.
▪
Install the frame and front cover in the reverse or-
der of disassembly.
4. Turn on the power supply.
3 Settings
Please be aware of the following:
▪
The floor temperature is measured where the floor
sensor is placed.
▪
The temperature of the bottom of a wooden floor
can be up to 10 degrees higher than the top.
▪
Floor manufactures often specify the max tempera-
ture on the top surface of the floor (usually 27-28˚C).
▪
Always use a floor sensor or a room + floor sensor
combination to control floor heating. Without a floor
sensor, the temperature control may be less accurate
and you risk overheating the floor.
DEVIreg™ 528
Installation Guide 9
To Next Page
Loading...
