▪
The installation of the thermostat must be done by an
authorized and qualified installer according to local
regulations.
▪
The thermostat must be connected to a power supply
via an all-pole disconnection switch.
▪
The sensor is to be considered as live voltage. Have
this in mind if the sensor must be extended.
▪
Always connect the thermostat to continuous power
supply.
▪
Do not expose the thermostat to moisture, water, dust,
and excessive heat.
2 Mounting Instructions
Place the thermostat at a suitable height
on the wall (typically 80-170cm.).
In wet rooms, place the thermostat accord-
ing to local regulation on IP classes.
DEVIreg™ 530
6 Installation Guide
To Next Page
Loading...
