54
Deviate Claymore User Manual v1.8 12.12.23Deviate Claymore User Manual v1.8 12.12.23
SAFETY INSTRUCTIONS (CONTINUED)
SUSPENSION
Suspension set-up and adjustment should be carried out according to the manufactures
recommendations. Please refer to the suspension manufacturers product instructions.
PRE-RIDE CHECKS
All bolts and fasteners should be checked before according to the recommendations in the
Maintenance section of this manual or the manufactures recommendations. Brake function and
tyre pressure, wheel fitment and the functioning of the suspension should be checked before
every ride. Additionally, normal functioning of pedals and drivetrain should be checked.
ENTRAPMENT
There is a risk of trapping body parts during maintenance and normal use. Care should be
taken when maintaining moving parts and appropriate protective equipment should be worn.
During normal use care should be taken to prevent loose clothing catching in the moving
parts.
LUGGAGE AND CHILD SEATS OR CARRIER
The bicycle is not suitable for the fitment of any luggage carrying device or any child seat or
carrier.
PERMISSIBLE WEIGHT
The total permissible weight of a rider including gear is 120kg.
PUBLIC ROADS
If used on public roads it is your responsibility to ensure your bike is legal and roadworthy
SEAT POST DROPPER CABLE
Visit www.vimeo.com/771996950 or
scan below for video guidance
TOP TUBE CABLE GUIDES
There are a number of cable clamps along
the length of the top tube. These provide
clamping for the cables, but also serve as
tool fixing points, Di2 or additional bottle
mounting.
ASSEMBLY
PARTS SPECIFIC STANDARDS
Interface Specication
Fork Compatibility 29” 170-180mm (42mm and 51mm offset) single crown
forks only. Fork crown interference with downtube
MUST be checked before fitting forks.
Bottom Bracket 73mm BSA Threaded
Headset ZS44/ZS56
Chainline 52mm (any deviation from this will cause increased
idler wear)
Chain Length 126 links (widely available, no need to join chains)
Max Chainring Size 36t round (oval chainrings may fit depending on
design but check for interference before riding)
Shock Size Metric 230x60mm (coil or air)
Shock Hardware Front: 40x8mm | Rear: bushing
Shock Average Leverage Ratio 2.54 mm/mm
Brake Mount Post Mount 180mm (Max 203mm Disc Size Rear)
Seatpost Compatibility Internal dropper routing with internal cable routing.
34.9mm, Minimum Insertion Depth: 150mm.
Maximum Insertion Depth: Medium:- 300mm,
Large:- 330mm, XL:- 360mm
Seat Collar 38.5mm (supplied with frame)
Max Tyre Size 2.8”
Deviate Cycles recommends this bike is assembled by a competent bike mechanic.
To Next Page
Loading...