15
ENGLISH
Servicing after use
After every use, check the water in the water tray and discard it, clean the water tray and the
steam nozzle, and wash all parts which can be washed.
Emptying and cleaning the water tray
When water accumulates in the water tray, the
yellow float appears in the hole of the water
tray cover.
Immediately empty the water tray when the
entire float hole appears yellow. It is recom-
mended to empty the water tray early.
Water discharged
from the pump
comes out here.
This product has a built-in safety valve to pro-
tect the pump from excessive pressure.
Water discharged from the safety valve and
water spilled from the water tray cover is col-
lected in the water tray. Empty and wash the
water tray after each use.
Please note that it is easy to overlook the wa-
ter discharged from the pump and pay atten-
tion to the yellow float.
Float
• Raise the front of the water tray a little to
remove and insert it.
• Set the water tray so that it hits the rear
separation.
Emptying the water tank
As water can freeze and damage the product
when the temperature is low, empty the tank
and store it in clean condition.
Cleaning the body
Before cleaning, switch off the power, pull the
plug from the outlet, and wait for the parts to
cool sufficiently before wiping dry with a soft
cloth.
In case of severe dirt, wipe clean with a cloth
moistened with neutral detergent, and then
wipe off any detergent with a moist cloth.
The main body must not be immersed.
Water washing
Water tray, water tank, water tray cover, pod
tray set, and outer steam nozzle can be washed
with water. It is recommended to wash these
parts with running water after each use.
Do not use detergent, as this may impair the
coffee aroma.
Cleaning the steam nozzle.
Clean the steam nozzle after each use by pass-
ing steam through it, as described in step 2 on
page 12. The nozzle can clog when it is left
standing with milk on it.
Take care not to hurt yourself on the tray cover
edges etc.
Float
To Next Page
Loading...