deviceSTYLE Brunopasso PD-1 - Cleaning of Float Part and Filter Tray Set

18
ENGLISH
After use for a long time, disassemble the float part installed on the water tray and the pod tray
set and wash them with water.
Float part and pod tray set can be disassembled as shown below.
Descaling (continued)
Float
Pod tray set
Water tray
When citric acid remains, the
bitter taste and smell will harm
the taste of the coffee.
Wash repeatedly with fresh
water to remove any citric
acid.
[ Float part]
The float part is installed as a set with the float holder by insertion into the tray rib (partition). For
cleaning, remove the float from the float holder and wash it.
After cleaning, set the float into the float holder and insert them to the rib (partition) of the water
tray.
• For some time after use, the pod holder and its surroundings remain very hot. Take
sufficient care to prevent burns.
• When handling metal parts like the float part or the water tray cover, take care not to
hurt yourself on the edges etc.
[Pod tray set]
Cleaning of float part and filter tray set
Tips
Pod filter
Pod tray
Float holder
Float
Fresh
water
Replace the solution by fresh water
to remove the citric acid.
① Replace the citric acid solution by fresh
water and repeat steps 1 and 2 on
pages 16 to 17 to thoroughly remove
any citric acid.
② Install the water softening resin filter
and return it into the water tank.
3.
Tube
Water tank
Water soften-
ing resin filter
①
②