deviceSTYLE Brunopasso PD-1 - Page 6

6
ENGLISH
Pass hot water through the
espresso extraction opening and
clean it.
① Press the “push release” (Tank open)
button to open the tank cover.
3.
Before first use (continued)
⑥
push
release
② Take out the water tank.
1）
2）
③ Fill water into the water tank.
Fill in max. 1.5 liters of water.
Do not fill water above the indicated line.
This unit is equipped with a
water softening resin filter in
the tank, and hard water is
changed to soft water, but
with use for a long time, min-
erals will be deposited in the
water passages. Continued
use in this condition will cause
trouble.
The water softening resin fil-
ter should be replaced ap-
proximately every 2 months
with normal use.
⑤ Pull the handle all the way down and
set a cup.
1) Push the handle securely all the way down.
2) Set a cup onto the tray cover.
⑥ Insert the plug of the power cable into
a wall outlet.
Do not fill in
water above
this line.
①
③
④
⑤
Perform the operation without
setting a coffee pod.
Connect the power
cable directly to a wall
outlet. Connection to
an extension cable is
not only dangerous,
but the supplied volt-
age may not be suffi-
cient for the product to
exhibit its full perfor-
mance.
②
When removing the water tank, hold the ma-
chine down so that it will not move.
④ Set the water tank into the body.
At this time, insert the tip of the hose in the tank
securely into the water supply port of the body.
Incomplete insertion can lead to leakage of water.
Push the tank cover to close it.
Check once more that the handle has
been pushed down securely. The
handle may jump up when it is not
pushed down sufficiently.
Switch on the power for the operations
shown on this page.
Tips
Tips
Tank hose
Body water
supply port