9
ENGLISH
Preparing espresso coffee (continued)
Pay attention to the size of the cup.
Large cups like mug cups etc. cannot be set to this product.
Also, when a large cup has been set and the handle is operated, the pot
holder may hit and break the cup when it is lowered.
For safety reasons, always op-
erate the handle after the cup
has been removed.
Perform the operation without
setting a coffee pod.
The handle must be lowered
correctly to the horizontal po-
sition.
2.
①
② Press the espresso POWER button.
Perform the following operation
after the temperature indication
of the espresso thermometer is
in the green range and the
needle has stopped rising.
③ Press the espresso extraction ON/OFF
button.
Press the espresso extraction ON/OFF button
again to stop when the cup is full.
(There is no automatic stop.)
When hot water is passed,
the operation noise increases,
but this is normal.
Also, when the espresso
ON/OFF button is pressed to
stop extraction, hot water
may continue to drip, but this
is also normal.
④ Remove the cup and raise the handle.
1) Remove the cup to the tray cover and discard
the hot water.
2) Raise the handle all the way.
④
1）
2）
espresso
POWER
②
1）
2）
espresso
POWER
③
First, warm the cup (no coffee pod
is used for this operation).
① Lower the handle to the horizontal
position and set a cup.
1) Push the handle securely all the way down.
2) Set a cup onto the tray cover.
Tips
Tips
Tips
When the handle is held
down (the pot holder raised)
for one or two minutes di-
rectly before setting the cof-
fee pot, the pot holder is
heated and even hotter cof-
fee can be poured.
Please be careful, as the
top of the body becomes
hot during operation.
To Next Page
Loading...